Slope protection mold should be packed tightly and neatly.
护坡模具应包装紧密、整齐。
The
mold should be strictly checked in the warehouse to prevent the
inferior or aging plastic products of molecular compounds from entering
the warehouse.
模具应严厉入库检验,制止质次或已老化蜕变的份子化合物塑料制品入库。
It should be
packed tightly and neatly, inspected when entering and leaving the
warehouse, inspected when entering the warehouse, and prevented the mold
with inferior quality or aging from entering the warehouse.
要包装紧密、整齐,在出入库时进行检查,入库时要检验,制止质量过次或老化的模具进入库房。
Adhere
to the health of the warehouse, brush white on the walls and doors and
Windows, avoid direct sunlight, and can not store corrosive products
with the warehouse.
坚持库房的卫生,在墙面和门窗上刷上白色,避免阳光直射,不能同仓贮存腐蚀性较强的产物。
Also
pay attention to moisture, sun protection, wind, rain, etc., but also
adhere to humidity and temperature, to avoid chemical reactions in the
slope protection mold, resulting in changes in the physical condition.
还要注重防潮、防晒、防风、防雨等,还要坚持湿度和温度,避免护坡模具发作化学反应,招致物理状况改动。
The
bottom warehouse should be isolated from the ground tide, and the
open-air cargo stack should be done with sun protection, rain
prevention, wind protection, and avoid exposing the stack.
底层库房要隔离地潮,露天货垛要做好防晒、防雨、防风、避免露垛。
Enhance
the temperature and humidity management of the mold warehouse,
molecular compound plastic products usually require an appropriate
temperature below 27 ° C, and the relative humidity of 70% to 80.
增强模具的库房温湿度办理,份子化合物塑料制品通常需求相宜温度在27℃以下,相对湿度70%~80。
